62
Use MIDI functionality
Specifying the button mode
When you make Assign settings (p. 61) in Edit mode to assign a message to a button, you must
specify the operating mode of the button (button mode).
When you use a button as a controller, turning the button on will transmit the maximum
specified value, and turning it off will transmit the minimum value.
1.
Press the
[0]
or
[1]
key to select either
Latch mode
or
Toggle mode
.
2.
Press the
[ENTER]
button.
0
Latch mode
The setting will turn on when you press the button, and off
when you release it. The button will remain lit while you are
pressing it.
1
Toggle mode
The setting will alternate on/off each time you press the but-
ton. The button will light when an On message is transmitted,
and will go dark when an Off message is transmitted.
Specifying the port
When you are making Assign settings (p. 61) in Edit mode and have selected Advanced mode,
you must specify the USB port to which the message assigned to the controller will be sent
when using a USB connection.
1.
Press a key
[1]
–
[3]
to select the port.
2.
Press the
[ENTER]
button.
* For details on the port, refer to
1
PORT 1
Messages will be sent to
“PCR-1 1”
2
PORT 2
Messages will be sent to
“PCR-1 2”
3
PORT 1, 2
Messages will be sent to both
“PCR-1 1”
and
“PCR-1 2”
PCR-1_e1.book 62 ページ ２００３年１１月２０日 木曜日 午後３時２２分
Summary of Contents for Edirol PCR-1
Page 98: ...98 MEMO PCR 1_e1 book 98...
