71
Use MIDI functionality
■
PROGRAM CHANGE ASSIGN
Here’s how to assign a program change message to a controller.
Basic mode
fig.edt2
1
Press the
[EDIT]
button.
The display will indicate “EDT.”
fig.r-1
2
Slightly move the controller to which you want to assign a Program Change
message. In the case of a button, press that button.
The display will indicate the number of the selected controller.
3
Confirm what’s indicated, and press the
[ENTER]
button.
fig.pc0
4
Press an
ASSIGNABLE FUNCTION
key (
) on the keyboard enough times
to get "PC0" to appear in the display.
fig.c
5
Confirm what’s indicated, and press the
[ENTER]
button.
The display will indicate “C–”.
6
Input the channel. Use the
[DEC] [INC]
buttons or the
[0]
–
[F]
keys to specify the channel.
fig.n
7
Press the
[ENTER]
button.
The display will indicate “N–”.
8
Use the
[DEC] [INC]
buttons or the
[0]
–
[F]
keys to specify the program change number.
9
Press the
[ENTER]
button.
* If you assign Basic mode to
[S1]
–
[S8]
or
[R1]
–
[R8]
, moving the controller up to the maximum
position will transmit the assigned program change messages.
Mode
Number
Effect
Bank
Port
Basic mode
0
Fixed value
Not output
PORT 1
Advanced mode 1
1
Assignable range of values
Not output
PORT 1
Advanced mode 2
2
Fixed value
Output
Assignable
Advanced mode 3
3
PC DEC
Not output
PORT 1
Advanced mode 4
4
PC INC
Not output
PORT 1
*1 Reference
*1 Reference
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or mode
of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently set value,
or will blink if the value is different.
PCR-1_e1.book 71 ページ ２００３年１１月２０日 木曜日 午後３時２２分
Summary of Contents for Edirol PCR-1
Page 98: ...98 MEMO PCR 1_e1 book 98...
