77
Use MIDI functionality
■
Sys Ex. ASSIGN
Here’s how you can assign a system exclusive message to a controller. Advanced mode 2 lets
you assign a single-byte system message (System realtime message, tune request).
Advanced modes 3 and 4 let you assign any desired message. (Input up to 24 bytes)
Sys Ex. ASSIGN can calculate the checksum automatically, and lets you specify a variable (data)
range or embed a channel/block number within the message. (
In Sys Ex. ASSIGN, the input mode will be HEX mode.
fig.edt2
1
Press the
[EDIT]
button.
The display will indicate “EDT”.
fig.r-1
2
Slightly move the controller to which you want to assign the system exclusive
message. In the case of a button, press that button.
The display will indicate the number of the selected controller.
3
Confirm what’s indicated, and press the
[ENTER]
button.
fig.se0
4
Press an
ASSIGNABLE FUNCTION
key (
) on the keyboard enough times
to get "SE0" to appear in the display.
5
If you want to select an Advanced mode, press a key from
[1]
to
[4]
.
The selected mode will blink in the display.
6
Confirm what’s indicated, and press the
[ENTER]
button.
Then continue with the procedure described in Basic mode or Advanced mode (p. 78).
For some actual examples of settings, refer to
Examples of assigning system exclusive
Mode
Key-
board
Mode
Value range
Required ending
Notes/restrictions
Basic mode
0
Sys Ex. message Default range
Input F7
1st byte fixed at F0
Advanced mode 1
1
Sys Ex. message Assignable
Input F7
1st byte fixed at F0
Advanced mode 2
2
Single byte sys-
tem message
–
–
[0–5, 7, 9, D, E]
[DA-
TA][CHECKSUM]
but-
tons are invalid
Advanced mode 3
3
Any desired
MIDI message
Default range
Specified number of bytes
[CHECKSUM]
button is
invalid
Advanced mode 4
4
Any desired
MIDI message
Assignable
Specified number of bytes
[CHECKSUM]
button is
invalid
PCR-1_e1.book 77 ページ ２００３年１１月２０日 木曜日 午後３時２２分
Summary of Contents for Edirol PCR-1
Page 98: ...98 MEMO PCR 1_e1 book 98...
