95
System settings
H-ACTIVITY ON / OFF (Keyboard : 5)
fig.hyo
Perform steps 1-3.
4.
Use the
[DEC] [INC]
buttons or the
[0]
or
[1]
keys to switch H-ACTIVITY
ON / OFF.
The display will indicate either “ON” or “OFF”.
5.
Press the
[ENTER]
button.
USB MIDI DRIVER MODE (Keyboard : 6)
Perform steps 1-3.
4.
Use the
[DEC] [INC]
buttons or the
[0]
or
[1]
keys to specify the USB MIDI DRIVER
MODE.
*
FPT = Fast Processing Technology for MIDI Transmission:
Effective use is made of the USB bandwidth according to the amount of MIDI data to be transmitted,
ensuring that MIDI data processing will always occur optimally.
5.
Press the
[ENTER]
button.
STARTUP MEMORY (Keyboard : 7)
Perform steps 1–3.
4.
Use the
[DEC] [INC]
buttons or the
[0]
or
[1]
keys to specify the GM2/LAST ACCESS
MEMORY setting.
5.
Press the
[ENTER]
button.
FACTORY RESET (Keyboard : 8)
Perform steps 1–3.
fig.rst
4.
The display will indicate “RST”.
fig.yes
5.
Press the
[ENTER]
button.
The display will blink “YES”.
6.
Press the
[ENTER]
button.
0
Original driver
FPT technology is used to perform high-speed MIDI trans-
fer. Normally, we recommend that you use this mode.
1
Generic driver
Select this if you are using the standard MIDI driver provid-
ed by your operating system.
0
GM2 MEMORY
When the PCR starts up, memory number 0 (GM2) will
be loaded into
current memory
state in which the power was turned off.
1
LAST ACCESS
MEMORY
Upon power-up, the PCR-1 will recall the memory that
was last recalled or saved into
current memory
0
OFF
1
ON
PCR-1_e1.book 95 ページ ２００３年１１月２０日 木曜日 午後３時２２分
Summary of Contents for Edirol PCR-1
Page 98: ...98 MEMO PCR 1_e1 book 98...
