153
Edit mode (EDIT)
■
Transmit mode
fig.edt
1
Press the
[EDIT]
button.
The display will indicate “EDT”.
2
Press the
[BULK]
key.
3
Press the
[1]
key.
fig.blt
The display will blink “BLT” (Bulk Transmit).
4
Confirm what’s indicated and press the
[ENTER]
button.
fig.ts
The display will indicate “TS”, and the “S” will blink.
5
Use the
[DEC] [INC]
buttons or the
[0]
[1]
keys to select the mode.
6
Confirm what’s indicated and press the
[ENTER]
button.
fig.bs-1
7
The third digit of the display will blink, and the PCR-30/50/80 will wait
to transmit bulk data.
8
Press the
[ENTER]
button.
On your sequencer software, specify “PCR 2” as the MIDI input device. For details on this setting,
refer to the manual of your sequencer software.
For details on the port that will be used to transfer bulk data, refer to
fig.end
9
When the PCR finishes receiving the bulk data, the display will
indicate “END”.
10
Confirm what’s indicated and press the
[ENTER]
button.
0
SINGLE BULK
The currently recalled memory (the current
memory) will be transmitted as bulk data
1
ALL BULK
All memories (memories 1–F) will be transmitted
as bulk data.
Summary of Contents for Edirol PCR-80
Page 124: ...124 MEMO ...
