21
&
&
Various settings (Function mode)
Function mode lets you make various settings for the F-120R.
Basic Operation in Function Mode
Here’s the basic procedure for making settings in Function mode.
1.
Press and hold the [Split] button and press the
[Transpose] button .
The display looks more or less as follows (this depends on the last
function you selected since switching the F-120R on.
TwinPno
OFF
Depending on which function is displayed, there may be one or two
white arrows in the top line. If the left arrow is missing, pressing the
[–] button has no effect. If the right arrow is missing, pressing [+]
has no effect.
2.
Use the [–] or [+] button to select the desired function .
3.
Press the [Metronome] button to activate value selection .
Now, the bottom line contains one or two white arrows:
KeyTouch
L2
4.
Press the [–] [+] buttons to edit the value of the setting .
Reference
For details on the values of each function, refer to “Function
Memo
By pressing the [Metronome] button you can return to the
function setting screen. If you want to edit other function
settings, repeat steps 2–4.
5.
Press and hold the [Split] button and press the
[Transpose] button to leave Function mode .
Saving the Settings (Memory
Backup)
When the F-120R’s power is turned off, it will return to its default
settings. However, if desired, you can save the following settings so that
they will be remembered even after the power is off. This is called the
“Memory Backup” function.
Settings saved by Memory Backup
Page
Twin Piano Mode
One Touch
Master Tuning
Key Touch
Rhythm Hold
Transpose Mode
Split Off Recognize
Split On Recognize
Bass Inversion
Volume Left Tone
Center Pedal
Left Pedal
Visual Control Channel
MIDI Transmit Channel
USB Driver
Auto Off
Reverb
Brilliance
Auto Fill
1.
Hold down the [Split] button and press the [Transpose]
button .
The display will the name of the last function you selected since
switching on the F-120R.
2.
Press the [–] or [+] button a number of times until
“Backup” is shown in the display .
3.
Press the [Metronome] button .
Sure?
N Y
If you decide not to save the settings, press the [–] button.
4.
To save the settings, press the [+] button to select “Y” .
When the memory backup has been completed, the display returns
to “Backup”.
5.
Hold down the [Split] button and press the [Transpose]
button to leave Function mode .