24
Apr.2003
Verify that the LCD display shows a sawtooth wave above and a sine wave
below, as follows.
fig.7-3_70
When you press the [8] button you will proceed to the test of the [DIGITAL
AUDIO INTERFACE OPTICAL/COAXIAL OUTPUT] jacks.
Use an Optical (angular connector) to connect the [DIGITAL AUDIO
INTERFACE OPTICAL OUT] jack to a device that has digital audio input -> line
out jacks. Use an audio cable to connect the line out of the connected device to
the [INPUT L] jack and [INPUT R] jack, and adjust the [VOLUME INPUT] knob.
Verify that the LCD display shows a sawtooth wave above and a sine wave
below, as follows.
fig.7-4_70
Use a COAXIAL (pin) cable to connect the [DIGITAL AUDIO INTERFACE
COAXIAL OUT] jack to a device that has digital audio input -> line out jacks.
Use an audio cable to connect the line out of the connected device to the
[INPUT L] jack and [INPUT R] jack, and adjust the [VOLUME INPUT] knob.
Verify that the LCD display shows a sawtooth wave above and a sine wave
below, as follows.
fig.7-4_70
Press the [8] button to proceed to the next test item.
8. D-Beam Adjustment test
This adjusts the sensitivity of the [D BEAM] controller.
This adjustment sets the optimal sensitivity for the controller by making
adjustments for two distances from the [D BEAM] controller; at 5 cm and at 45 cm.
Before you begin this test: The location of the Fantom must satisfy the
following conditions.
Do not place objects nearby the Fantom. (It must be at least 30 cm from
surrounding objects.)
Place the Fantom at a distance from large flat surfaces such as ceiling or walls.
(It must be at least 100 cm away from such surfaces.)
Do not place the Fantom where strong light, such as direct sunlight or electric
light, can fall on it.
When you enter the D-Beam Adjustment test, the LCD display will show as
follows.
fig.8-1_70
First make the “5 cm” setting for the [D BEAM] controller.
The LCD display will indicate “Low (5cm).”
Place your hand in parallel with the panel surface at a vertical distance of 5 cm
from the [D BEAM] controller, and press the [ENTER] button.
Do not move your hand while the lower part of the LCD display shows “Now
Adjusting...”
When the setting has been completed, you will automatically proceed to the
next setting.
Make the “45 cm” setting for the [D BEAM] controller.
The LCD display will indicate “High (45cm).”
Place your hand in parallel with the panel surface at a vertical distance of 45
cm from the [D BEAM] controller, and press the [ENTER] button.
Do not move your hand while the lower part of the LCD display shows “Now
Adjusting...”
When the setting has been completed, you will automatically proceed to the
next test item.
9. D-Beam test
This tests the operation of the [D BEAM] controller.
When you begin the D-Beam test, the LCD display will show as follows.
fig.9-1_70
Summary of Contents for Fantom-S88
