13
Introduction
Once the connections have been completed (p. 11), turn on power to your various
devices in the order specified. Turning on devices in the wrong order may cause
malfunction or damage to the speakers (or other components) of connected devices.
Turning On the Power
fig.power-on.eps
First, check that you are connected properly with the external MIDI
instrument. Then set the power switch on the FC-300 to “ON.”
fig.
When the power is turned on, the FC-300 starts up in Standard Mode.
Turning Off the Power
1
Switch off the power to the device connected to the FC-300.
2
Set the FC-300’s POWER switch to OFF.
Turning On the Power
First, check that you are connected properly with the RRC2 IN device. Then set the
power switch on the RRC2 IN device to “ON.”
fig.
Turning Off the Power
Switch off the power to the RRC2 IN device connected to the FC-300.
Turning the Power On and Off
When Using the FC-300 as a MIDI Foot Controller
When Using the FC-300 as a Dedicated Foot
Controller for an RRC2 IN Device (e.g., the VG-99)
In addition, it starts up with
the MIDI channel set to “1,”
but you can change the startup
MIDI channel if you want.
Carefully connect the RRC2
cable or Ether cable all the way
in—until it is firmly to the
RRC2 connector.
When the RRC2 IN device’s
POWER switch is set to ON,
the FC-300’s power switches
on automatically, regardless of
the position of the FC-300’s
POWER switch.
Although the FC-300 starts up
in Standard Mode, it may be
switched to a different mode
by means of settings received
from an RRC2 IN device.
Connect the RRC2 cable.
Turn on the power of RRC2 IN device.
1
2
FC-300_e1.book 13 ページ ２００７年４月２４日 火曜日 午前１０時１０分
