46
Other Features
Set the system parameters with the following procedure.
1
Press [UTILITY].
The [UTILITY] indicator lights, and the Utility screen appears in the display.
2
Press PARAMETER [
] [
] to call up the parameter you want to set.
Parameters that can be set and their screens are described in the next section.
3
Press VALUE [
] [
] to set the various parameters.
4
When you’ve finished making the settings, press [UTILITY] or [EXIT].
The data is saved, and FC-300 returns to the top screen.
Depending on where the FC-300 is placed, the display (on the right) may become
difficult to read.
If this occurs, adjust the display contrast.
1
Press PARAMETER [
] [
] to select “SYS:LCD Contrast.”
2
Press VALUE [
] [
] to adjust the contrast.
3
When you’ve finished making the settings, press [UTILITY] or [EXIT].
When the FC-300 is run on battery power, setting Economy Mode to ON enables
approximately 1.8 times continuous running time of the normal FC-300’s operating
mode.
1
Press PARAMETER [
] [
] to select “SYS:Economy Mode.”
2
Press VALUE [
] [
] to switch Economy Mode on and off.
3
When you’ve finished making the settings, press [UTILITY] or [EXIT].
Setting the System Parameters
Adjusting the LCD Contrast
Reducing Battery Consumption (Economy Mode)
The display and indicators
may flicker when Economy
Mode is set to ON, but this
does not indicate a
malfunction.
FC-300_e1.book 46 ページ ２００７年４月２４日 火曜日 午前１０時１０分
