19
Chapter 1 Quick Start
Chapter 1
Using Knobs to Modify the Tone (Realtime Modify)
The sounds of the HPD-15 have various
parameters
that determine the
loudness, pitch, and duration, and how the notes are sounded. By
modifying the
values
of each parameters, you can vary the tone.
Normally, you will adjust the parameter values to your liking before you
perform. However, some of the parameters can be freely modified while
you play. This is referred to as “
realtime modify
.”
fig.1-11
1
Press [SELECT] to select the parameter that you wish to modify.
The indicator at the right of the selected parameter will light.
2
Sound the pad (D Beam, ribbon) for the sound that you wish to
modify.
* The M-FX DEPTH and LFO parameters will apply in the same way to all pads/
ribbons/D Beam.
3
Turn the [REALTIME MODIFY] knob.
The selected parameter and the value being modified will be displayed, and
the sound will change.
fig.1-12
* If the multi-effects (p. 20) is off, turning the [M-FX DEPTH] knob makes no
modification.
* If the LFO Waveform (p. 38) is set to “OFF,” turning the [LFO RATE], [LFO
PITCH] and [LFO FLT/AMP] knobs makes no modification.
4
By repeating steps 1–3 you can create numerous variations in
the sound.
* By pressing [EXIT/MODIFY CLEAR] you can cancel any value changes you made
(
Modify Clear
).
In Edit mode (p. 35), you
can also use Realtime
Modify to adjust the
parameter values (p. 58).
1
3
Modify Lock
Hold down [SELECT], and
sound the pad (D Beam,
ribbon). It will be fixed to
the target of modification
and other pads cannot
become to the target. (The
[SELECT] indicator will
blink at this time.)
To unlock, hold down
[SELECT], and press
[EXIT].
When you turn the knobs
too fast, some noise may be
heard from some tones .
RTM
A1* PITCH +600
Hold down [EXIT/
MODIFY CLEAR], and
press [SELECT]. You can
excute Modify Clear and
cancel the Modify Lock at
the same time.
