24
Chapter 1 Quick Start
Changing the Settings of a Patch (EZ
Edit)
The process of modifying a patch is called “editing.” The HPD-15 provides
Easy (EZ) Edit mode for making basic settings, and Edit mode for making
settings in more detail. This section explains EZ Edit mode.
fig.1-20
1
Press [EDIT].
[EDIT] will blink, and you will enter EZ Edit mode.
2
Strike a pad to select the pad set (p. 25) that you wish to
modify. You can also select the D Beam or ribbons.
3
Press [
PARAMETER] or [PARAMETER
] to select the
parameter that you wish to modify.
4
To modify the value, either turn [PATCH/VALUE] or use
[PATCH NUMBER
] and [PATCH NUMBER
].
5
Repeat steps 2–4 to continue editing.
6
When you are finished editing, press [EXIT].
You will return to normal Play mode.
To learn how to make more
detailed settings, refer to
“Chapter 2 Modifying a
Patch” (p. 35).
1
3
4
6
If you press [EDIT] once
again, [EDIT] will light and
you will be in Edit mode (p.
35).
You can make your
selection rapidly by using
the Key Repeat Function (p.
31) or Skip Function (p. 32).
The settings you edit will
return to the original
values when you switch
patches. If you wish to keep
your changes, refer to
“Saving your settings
(Write) / Duplicating
settings (Copy)” (p. 56).
