49
Chapter 2 Modifying a Patch
Chapter 2
Modulation Delay (Mod Delay)
This effect adds modulation to the delayed sound, producing
an effect similar to a flanger.
Delay Left: 0.0–500ms
DelayRight: 0.0–500ms
Adjusts the time from the original sound until when the right
delay sound is heard.
Feedback: -98–+98%
Ctrl2
Adjusts the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
Fbk Mode: NORMAL, CROSS
Selects the way in which delay sound is fed back into the effect.
NORMAL
: The left delay sound will be fed back into the
left delay, and the right delay sound into the right delay.
fig.2-16.e
CROSS
: The left delay sound will be fed back into the
right delay, and the right delay sound into the left delay.
fig.2-17.e
Rate: 0.05–10.0Hz
LFO, Ctrl1
Adjusts the rate of modulation.
Depth: 0–127
Ctrl3
Adjusts the depth of modulation.
Phase: 0–180deg
Adjusts the spatial spread of the sound.
HF Damp: 200Hz–8kHz, THRU
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to THRU.
Tone:-15–+15
Adjusts the tone quality. Positive (+) settings will emphasize
the high range, and negative (-) settings will emphasize the
low range.
Effect Level: 0–127
RTM
Adjusts the output level of delay sound.
Direct Level: 0–127
Adjusts the output level of direct sound.
Time Control Delay (TimeCtrlDly)
This effect allows you to use pads/D Beam/ribbons to
control the delay time and pitch in realtime. Lengthening the
delay will lower the pitch, and shortening it will raise the
pitch.
Delay: 200–1000ms
LFO, Ctrl1
Adjusts the time delay from the direct sound until when each
delay sound is heard.
Acceleration: 0–15
Adjusts the time over which the delay time will change from
the current setting to a newly specified setting. The rate of
change for the delay time directly affects the rate of pitch
change.
Feedback: -98–+98%
Ctrl2
Adjusts the proportion (%) of the delay sound that is fed back
into the effect. Negative (-) settings will invert the phase.
HF Damp: 200Hz–8kHz, THRU
Adjusts the frequency above which sound fed back to the
effect will be cut. If you do not want to cut the high
frequencies of the feedback, set this parameter to THRU.
Pan: L63–Center–R63
Ctrl3
Adjusts the stereo location of the delay sound.
Tone: -15–+15
Adjusts the tone quality. Positive (+) settings will emphasize
the high range, and negative (-) settings will emphasize the
low range.
Effect Level: 0–127
RTM
Adjusts the output level of delay sound.
Direct Level: 0–127
Adjusts the output level of direct sound.
R in
R out
L in
L out
Feedback
Delay
Delay
R in
R out
L in
L out
Feedback
Delay
Delay
