24
Jul. 2015
JD-XA
Test Mode
Items Required
•
Computer (running Windows 7)
•
USB memory device (recommended: M-UF2G)
•
USB cable
•
MIDI cable
•
Foot switch (DP-2, etc.)
•
Expression pedal (EV-5) x 2
* Adjust the minimum volume knob to
0
.
•
Oscilloscope
•
Noise meter
•
Tester
•
R-05
*
(p. 29) can also be tested with
an oscillator and a DI-1.
•
Amp-equipped monitor speaker
•
Headphones
•
Dummy plug
•
USB driver
Obtain this from the following web pages, and install it on the computer
just described.
http://www.roland.co.jp/
http://www.roland.com/
•
KY004_MIC.WAV
Obtain via Service Net, and copy it to the SD card in the R-05 just
described.
•
KY004_USB.WAV
Obtain via Service Net, and copy it on the computer just described.
Entering the Test Mode
Hold down
01
,
03
and
05
and switch on the power.
* Continue to hold down the three buttons above until the version is displayed on
the screen.
Quitting the Test Mode
Switch off the power.
Skipping Test Items
Shift
+
:
This forces execution to advance to the next test item.
Shift
+
:
This forces execution to return to the previous test item.
Shift
+
Menu
:
The test item select screen appears.
Use
or
to
select
the test item, then press
Enter
to jump to the
item.
* Some test items cannot be accomplished correctly unless testing is performed in
sequence.
* If pressing
Shift + Menu
in some test items, you can not return to the test item
select screen.
Test Items
Test items of
23–25
are carried out in the normal mode.
1. Version
This verifies the version of the program.
+————————————————+
|Appli:1.01(00**)|
|yy/mm/dd **:** |
+————————————————+
The version of the program is displayed on the screen.
1.
After verifying the version, press
+
.
The boot version is displayed.
+————————————————+
|Boot :1.00(00**)|
|yy/mm/dd **:** |
+————————————————+
Verify the boot version.
Summary of Contents for JD-XA
Page 11: ...11 Jul 2015 JD XA...
