6
The REPEAT A-B SETTING screen also plays an important role in track
editing, as we’ll see.
5
If you like, you can manually refine the A and B points to get them
more precisely where you want them, adjusting them either by bars
and beats, or by time.
You can clear either the punch-in or punch-out point—A or B,
respectively—by highlighting it onscreen and pressing 5 (CLEAR.)
6
Press 2 (AUTO) to turn on Auto-Punch.
7
Press EXIT to leave the screen.
8
Press the DIGITAL RECORDER REC button so it flashes, and
then make sure the track or pair of tracks you want to
punch is/are also flashing red.
9
Go to a spot in the song before the punch-in location so you have a
chance to get your bearings before recording begins.
10
Press the PLAY button to start playback.
When you get to the punch-in location, the REC light stops
flashing and the JUNO-Gi automatically punches in.
11
Play or sing what you want to fix.
When the song reaches the punch-out location, the JUNO-Gi
automatically punches out and REC starts flashing again.
12
Press STOP and listen to your punch. If it’s not good
enough, repeat Steps 8-11 to try again. You can attempt a
punch as many times as you need to.
13
When you’re done with punching, clear your punch point to turn
off Auto-Punching. To do this, press RECORDER VIEW to go to the
RECORDER screen, and then press the REPEAT A
3
4
B button once—
”Clear A-B” appears momentarily onscreen.
7
As soon as you’re done, press REC again to punch out.
8
Press STOP and go back to listen to your punch. If it’s
not good enough, repeat Steps 3-7 to try again. You can
attempt a punch as many times as you need to.
A connected foot switch—like a Roland DP-2, DP-10, or FS-5U—makes
manual punching much easier, since you can punch in and out in Steps 5 and
7 without using your hands. To set this up, connect your foot switch to the
JUNO-Gi’s PEDAL CONTROL jack, and set the System Control Pedal
Assign parameter to
RECORDER REC
, as described on page 81 in the
Owner’s Manual.
Automatically Punching in and Out
When you use the Auto-Punch feature,
you set your punch points ahead of time,
and then the JUNO-Gi automatically
switches in and out of recording for you
during the punch. You set it up using the
DIGITAL RECORDER area’s REPEAT A
3
4
B
button.
Here’s how to use Auto-Punch on a track
you’ve just recorded:
1
Start playback of the song before the area you want to punch.
2
When you get to the spot at which you want to punch in, press the
RECORDER REPEAT A
3
4
B button once. This sets the A, or punch-in,
point.
3
When you get to the spot at which you want to punch out, press
the RECORDER REPEAT A
3
4
B button once more. This sets the B, or
punch-out, point.
4
While holding down SHIFT, press the RECORDER REPEAT A
3
4
B
button to display the A-B SETTING screen.
