9
Parameter Guide
Parameter
Value
Explanation
CC#
AMP DYNAMICS
0–3
Adjusts the sensitivity at which velocity
controls the AMP ENV depth.
LFO WAVEFORM
SINE,
SQR,
S&H
Specifies the LFO waveform.
LFO RATE
0–1023
Specifies the rate of the LFO cycle.
29
LFO DELAY TIME
0–1023
Adjusts the time from when a key is pressed
until LFO modulation starts being applied.
27
ENV1 ATTACK
0–1023
Specifies the ENV1 Attack time.
83
ENV1 DECAY
0–1023
Specifies the ENV1 Decay time.
80
ENV1 SUSTAIN
0–1023
Specifies the ENV1 Sustain level.
85
ENV1 RELEASE
0–1023
Specifies the ENV1 Release time.
86
ENV1 KEY
FOLLOW-S
0–3
Specifies the ENV1 key follow in four levels.
With higher values, ADR times become longer
as you play lower on the keyboard, and
shorter as you play higher.
ENV2 ATTACK
0–1023
Specifies the ENV2 Attack time.
89
ENV2 DECAY
0–1023
Specifies the ENV2 Decay time.
90
ENV2 SUSTAIN
0–1023
Specifies the ENV2 Sustain level.
102
ENV2 RELEASE
0–1023
Specifies the ENV2 Release time.
103
ENV2 KEY
FOLLOW-S
0–3
Specifies the ENV1 key follow in four levels.
With higher values, ADR times become longer
as you play lower on the keyboard, and
shorter as you play higher.
BEND PITCH-STEP
2, 3, 4, 7
Specifies the range of pitch change produced
by pitch bend in four levels: 2, 3, 4, or 7
semitones.
49
MODULATION
LFO
-63–+63
Adjusts the depth of modulation.
PORTA MODE
OFF, ON
Turns portamento on/off. If this is on, the
pitch will change smoothly from one note to
the next-played note.
118
PORTA TIME
0–1023
Adjusts the time over which the portamento
pitch change occurs.
5
PORTA CRV
Specifies the pitch change curve for portamento.
ORIGINAL
Change according to the original curve of
the model.
LINEAR
Change in a linear curve.
EXP1
Change in a non-linear curve (gentle slope).
EXP2
Change in a non-linear curve (steep slope).
KEY MODE
Specifies how notes are sounded.
119
POLY
Polyphonic
SOLO
Monophonic
UNISON
Unison
SL-UNISON
Monophonic unison
AFT LFO
-63–+63
Sets how much aftertouch changes the LFO
intensity.
* This is only enabled for products with aftertouch.
AFT FREQ
-63–+63
Sets how much aftertouch changes the low-
pass filter intensity.
This is only enabled for products with aftertouch.
AFT LEVEL
-63–+63
Sets how much aftertouch changes the tone
volume.
* This is only enabled for products with aftertouch.
PITCH DRIFT
0–255
Adjusts the slight pitch drift that occurs when
notes are played on an analog synthesizer.
PARAM
EXPANSION
OFF, ON
If this is ON, the range of change for LFO
RATE, CUTOFF, RESONANCE, and FILTER ENV
DEPTH is wider than on the original model.
CONDITION
0–100
Simulates the changes that occur as a unit
ages.
