6
4.
Loosen the leg nut.
5.
Rotate the rubber foot to adjust the leg tip.
Adjust to use the spike legs when installing on carpeting
or other soft surfaces, or the rubber legs when installing on
flooring or other hard surfaces.
When shipped from the factory, the stand is adjusted for
using the rubber legs.
• The tip of the spike is sharp. Handle it with care.
• When using on flooring, the spike legs may damage
the floor. Adjust to use the rubber legs.
6.
Tighten the nut and rubber foot to secure the
rubber foot in place and keep it from loosening.
The nut and rubber foot must be tighten to prevent the
malfunctions.
7.
Loosen the T-bolts for the stay and mount the
legs on the stay.
Install the legs as shown in the figure so that the ends of
the legs protrude by about 1 inch (2 cm).
fig.K05.e
8.
Tighten the T-bolts to secure the legs to the
stand.
9.
Lift the KD-80 and place the stand and the four
legs upright.
10.
Adjust the angle of the stand plate so that it’s at
a right angle to the floor.
Loosen the T bolts that you tightened in step
, and adjust
the length of the legs so that the stand plate is vertical to
the floor. Then firmly tighten the T bolts.
11.
Install the included beater on your kick pedal.
12.
Mount the kick pedal on the KD-80.
fig.K06.e
• Install the kick pedal securely.
• Set the KD-80 so no mechanical noise is heard when
you step on pedal.
• Make sure that KD-80 does not touch the drum stand
or the other pads.
If you are using a kick pedal with an under plate
Adjust the length of the legs so that the four legs of the
KD-80 and the heel of the kick pedal contact the floor
evenly.
13.
Adjust the striking point for the beater.
The beater’s striking point is adjusted to fall at the center
of the head.
Adjust the striking point so that it doesn’t extend beyond
the cushion on the back of the head.
When Using a Twin (Double Kick) Pedal
With the KD-80, you can also play using a twin (double kick)
pedal.
Set this up so the striking points of the two beaters fall at equal
distances to the left and right of the center of the head.
When using a twin (double kick) pedal, as with a regular
pedal, use the included beater or a plastic beater as the beater
for the kick pedal.
fig.K07
Spike
Rubber Foot
Nut
Spike Leg
Rubber Leg
Extend the leg
by about 1 inch
(2 cm).
90
°
60
°
Adjust
the leg length
Stand plate
Under plate
Heel portion
Next
