4
Kiwi-3P Matrix Features
•
1024 Tones & 8 Sequences can be stored and edited, Sequences can be optionally linked to tones. It is also possible to
temporarily edit any Tone or Seq
•
Pulse Width Module is included with the Kiwi3P Matrix. This allows Pulse Width control and wave combinations.
•
Saw, Pulse Width & Square Waveforms can be solo or mixed in any combination.
•
Sysex support for all and MidiCC for most parameters, Midi Sysex support for Tone Dump & Load
•
Patch Editor Control of Parameters (requires PE v 8.3 or later)
•
Full Matrix system with 29 Source and 40 Destination types.
•
Key Assign Modes are Poly Single, Poly Dual, Poly Triple, Unison & Solo
•
Each Key Assign mode can have Rotate/Reassign, Staccato/Legato, Steal/No Steal with five steal modes (Highest, Lowest,
Oldest, Newest, Quietest)
•
Portamento in all key modes
•
Note Detune available in all key modes, DCO 1 & 2 have separate Tune controls (±12 semitones) and DCO2 has a Fine Tune
(±50 cents). There is also an Analogue Feel parameter that adds a small random detune to notes.
•
Master Synth Fine Tune adjust in both hardware and software.
•
Three independent envelope generators. These are traditional ADSR type and are modeled on the Original JX-3P. Each ENV
Mod can select from ENV 1 - 3 and has an Inverted or Normal modes. These are faster than the traditional JX-3P envelopes
•
Three independent Low Frequency Oscillators with 6 waveforms each. Each LFO Mod can select from LFO 1-3. LFOs can be
plus and minus base note or plus base note only.
•
Midi Note Aftertouch (Channel & Note), Midi and Internal Modulation Level and Midi Note Dynamics are all Matrix sources
and can be sent any Matrix Destination.
•
LFO Button is a Matrix Source and can inject mod control to any matrix destination(s)
•
Bend Lever is coded to DCO Frequency for Bend but is also a Matrix Source which can be sent to any Destination
•
Front panel editing is available for all parameters. These can be edited via midi or the PG-200.
•
Master, Sequencer and Arpeggiator clocks can optionally display on the front panel
•
Key transpose allows transposition to any key. The range for this is -1 Octave to +2 Octaves
•
Chorus has Manual Mode & variable speed
CHORD MODE
•
Any chord with up to 6 notes can be set and played from any key
ARPEGGIATOR
•
The Arpeggiator is clocked from the Master Clock and can be independently divided to Half Note, Quarter Note, 1/8 Note, 1/8
Note Half Swing, 1/8 Note Full Swing, 1/8 Note Triplets, 1/16 Note, 1/16 Note Half Swing, 1/16 Note Full Swing, 1/16 Note
Triplets, 1/32 Note, 1/32 Note Triplets, 1/64 Note.
•
Arp modes are Up, Down, Up and Down, Random, As Played, 1, 2, 3 or 4 octaves
•
Arp can be Started, Stopped & Continued using Midi Commands
•
Appeggiator will Output Midi Data
SEQUENCER
•
8 separate 124 Max step Polyphonic sequences can be created and stored
•
Sequences can be edited
•
The Sequencer is clocked from the Master Clock and can be independently divided to Half Note, Quarter Note, 1/8 Note, 1/8
Note Half Swing, 1/8 Note Full Swing, 1/8 Note Triplets, 1/16 Note, 1/16 Note Half Swing, 1/16 Note Full Swing, 1/16 Note
Triplets, 1/32 Note, 1/32 Note Triplets, 1/64 Note.
•
Sequencer can be Started, Stopped & Continued using Midi Commands
•
Sequencer will Output Midi Data
PG-200
•
Full PG-200 support
•
PG-200 will output midi data
Kiwi-3P Matrix Upgrade User Manual v1.2
Summary of Contents for KIWI-3P
Page 5: ...5 Front Panel Description www kiwitechnics com 3P Matrix Upgrade User Manual v1 2 ...
Page 6: ...6 Basic Connections www kiwitechnics com 3P Matrix Upgrade User Manual v1 2 ...
Page 7: ...Menu Flow Chart ...
Page 8: ...8 Edit Map www kiwitechnics com 3P Matrix Upgrade User Manual v1 2 ...
