Performing Advanced Setup of the Media
13
Chapter 1 Fully Utilizing the Machine
4.
Press [ ] or [ ] to select a value .
SET AT SETUP
Explanation
DISABLE
(Default setting)
Setup is performed using the print area of the previous setup .
The factory default print area is the full area (770 × 330 mm [30 .3 × 13 in .]) .
This setting is suitable when you always perform printing on media of a fixed size .
ENABLE
Set the print area (base position, width, and length of the print area) every time you set
up the media .
Select this value when the media shape changes for each printing operation .
5.
Press [ENTER] .
6.
Press [MENU], then [ ] to go back to the original screen .
Changing the Print Area
In the factory defaults, the base position (home position) of the print area is at the right front of the flat table
and the print area is the full area (770 × 330 mm
[30 .3 × 13 in .]
) .
The base position of the print area should be changed according to the shape of the media .
You can reduce the print time if you narrow (limit) the print area .
Determining the Base Position of the Print Area (Home Position)
Determine the home position used as the base to set the print area .
1.
Press [MENU] .
2.
Press [ ] twice to display the screen shown below .
MENU
SUB MENU
3.
Press [ ] .
4.
Press [ ] to display the screen shown below .
SUB MENU
SET BASE POS.
5.
Press [ ] .
SET BASE POS.
LOWER R LOWER R
