33
Setting from the Control Panel
Initializing the Settings
The QUAD-CAPTURE allows you to initialize each setting.
1.
From the “Device” menu, select [Initialize].
The confirmation screen will appear.
2.
Click [OK] to carry out the initialization, or click [Cancel] to cancel without initializing.
Checking the Signal Flow
You can check the signal flow by displaying a block diagram.
1.
From the “Device” menu, select [Show the signal flow].
Setting the Input from the COAXIAL IN (3/4) Jack
You can set whether the digital signal is received or not.
1.
From the “Device” menu, select [Device settings].
2.
From the items in “Digital In,” select “AUTO” or “OFF.”
Indication
Description
AUTO
A digital signal that is input from the COAXIAL IN (3/4) jack will be received.
The QUAD-CAPTURE will switch to the same sampling rate as the incoming digital signal.
OFF
The digital signal that is input from the COAXIAL IN (3/4) jack will not be received.
