38
2. Basic Operation
2-3 Loading Media
Loading Roll Media
1
Open the front cover.
2
Line up the media flanges with the edges of the roll media, aligning them with the inner diameter of the
core of the roll media.
3
Place the roll media on the shaft.
Pass the end of the media between the pinch
rollers and the grit rollers so that it extends from
the front of the machine.
When loading roll media, be sure to install the shafts.
Otherwise the roll may fall and cause injury.
Load roll media at the proper position.
Otherwise the roll may fall, resulting in injury.
Never touch the rail or the inner sides of the covers.
Touching the area may cause the fingers to be soiled by grease or ink, and may result in diminished image quality.
2 in.
3 in.
Roll media
Shaft
Summary of Contents for SP-300
