26
Chapter 3: Performing Cutting
3-1 What to Know Before Cutting
Useable Material Types
The following materials can be used with this machine.
SV-15
SV-12
SV-8
Width: 360 to 381 mm
Width: 280 to 305 mm
Width: 200 to 215 mm
(14-1/8 to 15 in.)
(11 to 12 in.)
(7-13/16 to 8-7/16 in.)
280 to 305 mm (11 to 12 in.)
(A3 length, A4 width)
(A4 length)
(A3 length, A4 width)
Length: 1100 mm
Length: 1100 mm
Length: 1100 mm
(43-1/4 in.) or less
(43-1/4 in.) or less
(43-1/4 in.) or less
* The machine may not cut certain materials.
➢
Do not use material that is in a condition indicated below. It may come loose or jam during cutting.
Using Roll Material
If you're using a roll of material, make sure to add a margin greater than 40 mm (1-5/8 in.) to the cutting area
prior to cutting the material from the roll. Material with a maximum length of 1100 mm (43-1/4 in.) can be loaded
into the machine. However, the cutting area is only 1000 mm (39-5/16 in.).
➢
Cut the material at a right angle. If the front edge of the material is uneven, it may feed improperly during
cutting and could skew diagonally and come loose.
The material is longer than
1100 mm (43-1/4 in.)
The material is
curled upward.
The material edge is
not straight
The left and right
edges of the material
aren't parallel
Up to
1100 mm
(43-1/4 in.)
Material Types
(*)
Vinyl chloride material (material section thickness is 0.1 mm or less, thickness including the backing
paper is 0.3 mm (0.012 in.) or less)
Label paper (Thickness including backing paper is 0.3 mm (0.012 in.) or less)
Size
Summary of Contents for Stika SV-12
