15
Connect the pads and pedals to the TD-8
About the Included Cables
Using the provided cables, connect the pads and pedals to the
TD-8.
• Carefully refer to the numbers shown in the illustration
and connect to the appropriate TRIGGER INPUT jacks on
the TD-8’s rear panel.
• Connect the L-shaped plug of the included cable to the
pad.This will prevent strain from being applied to the
pad.
Connecting the CY-12R/C
1.
Use the included cable to connect one of the CY-
12R/C’s output jacks (either one, but not both) to
the TD-8's trigger input jack.
If the CY-12R/C is to be used as a crash cymbal,
connect it to the BOW/EDGE output jack; if it is to be
used as a ride cymbal, connect it to the BOW/BELL
output jack.
2.
Secure the cable with cable ties.
Secure the cables in place with the cable tie, while leaving
some slack in the cables to ensure that they are not pulled
by the movement of the cymbal units when struck.
fig.CY04.e
Take care to ensure that the cables do not touch the
cymbal units and/or the stand. A cable touching a
cymbal unit or a stand may cause double sounding or
other incorrect operation.
3.5 m
2 m
1 m
Tighten it not to slip
Wind the cable
tie twice
Secure the cable
with the cable tie
Leave
some slack
Turn back
to fix the cable
When you have finished making the connections, proceed with the
TD-8's settings.
Settings optimized for the TD-8KV are provided in factory settings on the TD-8 (Trigger Bank 1).
1.
Press [SETUP]
→
[F1 (TRIG)].
2.
Check to see if you have things set as shown in the screen below.
3.
If your settings are different, make the trigger settings as described in the owner's manual provided with
the TD-8.
