■
Mixer settings for each part
Procedure
1.
Press [PART]-[F2 (MIXER)].
The mixer setting page will appear.
2.
Press [F1]–[F4] to select the parameter that you wish to
set.
3.
Use [CURSOR] to move the cursor to the part that you
wish to set.
4.
Use [INC/DEC] or the VALUE dial to make the setting.
Parameters
VOLUME ([F1]): 0–127
Adjusts the volume.
PAN ([F2]): L15–CENTER–R15
Adjusts the left/right(pan) position of the sound. “L15” is
far left, “C” is center, “R15” is far right.
* If you have chosen headphones (Phones Only) as the output des-
tination, the sound will be located in the center regardless of this
setting.
FXSEND ([F3]): 0–127
Adjusts the effect send level.
OUTPUT ([F4]): MASTER, PHONES
Select the output destination of the sound. The sound cannot
be output from the DIRECT 1, 2, 3 outputs.
MASTER:
Output from the MASTER OUT and PHONES
jacks
PHONES:
Output only from the PHONES jacks
■
Muting a specific part
Procedure
1.
Press [PART]-[F4 (MUTE)].
The “PART MUTE” page will appear.
2.
Press [F1]–[F4] to turn muting on/off.
The [F1]–[F4] buttons correspond to Part 1, Part 2, Bass part,
and the Drum part. Muting will be switched on/off each
time you press the button.
Chapter 6. Sequencer
107
Chapter 1
Chapter 2
Chapter 3
Chapter 4
Chapter 5
Chapter 6
Chapter 7
Chapter 8
Chapter 9
Chapter 10
Summary of Contents for V-DRUMS TD-10
Page 21: ...Quick Start Quick Start 21...
Page 131: ...Appendices Appendices 131...
