This section lists the messages (error messages) that the TD-
10 produces and explains the meaning of each message, giv-
ing you the appropriate action to take. If the TD-10 is not
able to operate correctly or if an incorrect operation was per-
formed, a message window will appear in the screen. Read
this section and take the appropriate action.
When an indication of “ACCEPT” is shown above [F4] as in
the following figure, pressing that button will close the mes-
sage window.
fig.12-02
Backup Battery Low !
The internal backup battery of the TD-10 (a battery that
maintains data in the user memory) has run down. Contact
your dealer or a nearby Roland service center to have the
battery replaced.
BACKUP NG !
The backup battery has run down completely, and the inter-
nal data has been lost. Contact your dealer or a nearby
Roland service center to have the battery replaced.
BULK DUMP Aborted by User !
Bulk data transmission was halted.
Check Sum Error !
The checksum value of a system exclusive message was
incorrect.
BULK DUMP Data Transmit Completed !
Bulk data transmission was completed.
BULK DATA DEVICE ID Error !
Due to an incorrect Device ID, the system exclusive message
could not be received. Set the correct Device ID (p. 122).
BULK DATA Load Error !
Reception of bulk dump failed. Make sure that all MIDI
cables are firmly connected (p. 122).
BULK DATA Receiving ... Please, Wait.
Bulk data is now being received. (Don’t touch any buttons or
pad during this process).
BULK DATA Receive Completed !
Bulk data reception has ended.
Empty Pattern
You attempted to perform an editing operation on an empty
pattern.
EXPANSION BOARD Not Ready or
Unavailable !
Either the expansion board has been removed or was not
installed correctly (p. 43).
ILLEGAL CARD
This message may be due to one of the following two rea-
sons:
1. Check whether the card has been used by a different
Roland device.
Check whether the card has been used by a different Roland
device. If you wish to erase the contents of the card and use
it with the TD-10, press [F4 (ACCEPT)]. The card initialize
page will appear. In this page, press [F4 (INIT)] and you will
be asked whether it is OK to erase the contents of the card.
To initialize the card, press [F4].To cancel, press [F1].
2. Make sure that you are using an “M-512E” card ONLY.
MEMORY CARD Battery Low ! Please
Change !
The backup battery of the memory card has run down. Refer
to the owner’s manual for your memory card, and replace
the battery.
MEMORY CARD Data Error !
There is a problem in the data of the memory card. If the
power is turned off or the card removed while data is being
written into the card (SAVE), the data in the card will be
damaged. Format the card once again before using it (p.
114).
MEMORY CARD Data Load Completed !
Data has been loaded from the memory card.
MEMORY CARD Data Save Completed !
Data has been saved to the memory card.
MEMORY CARD Not Ready !
A pattern or drum kit chain attempted to access data from a
memory card. Insert the memory card.
MEMORY CARD Write Protected.
The memory card is write protected (switch in the “write
prohibit” position), and data could not be saved. Move the
write protect switch of the card to allow data to be saved (p.
114).
Message / error message list
138
Summary of Contents for V-DRUMS TD-10
Page 21: ...Quick Start Quick Start 21...
Page 131: ...Appendices Appendices 131...
