■
Customizing the tone (Equalizer)
Here you can adjust the high and low frequencies balance
for the instrument assigned to each pad. (TRIGGERS 1-10
only)
* This setting is not available for the AUX1,2 trigger inputs.
fig.06-06
Procedure
1.
Press [CONTROL ROOM]-[F3 (EQ)].
The “EQ” page will appear.
2.
Strike the pad that you wish to edit.
The setting page for the pad you struck will appear.
3.
Use [CURSOR] to move the cursor to the parameter that
you wish to set.
4.
Use [INC/DEC] or the VALUE dial to make the setting.
In this page, [F1] will turn the equalizer on/off. Pressing [F3]
or [F4] will move the cursor directly to the low range (LOW)
or high range (HIGH) settings.
Parameters
TYPE: Peak, L shelv, H shelv
Peak:
The vicinity of the specified frequency range will be
boosted/cut.
L shelv: The entire range below the specified frequency will
be boosted/cut.
H shelv: The entire range above the specified frequency will
be boosted/cut.
Q: 0.5, 1.0–20, 1.0 steps
Adjusts the width of the frequency range that will be boost-
ed/cut. For example, when the “Q” value is small, raising or
lowering the low range “GAIN” will affect a broad area
extending close to the high range.
FREQ (Frequency): 20–20 kHz
Adjusts the point at which the boost/cut will occur.If you
wish to boost/cut a range that is higher than the current
range, you would adjust this setting.
GAIN: -15–0–+15 dB
Adjusts the amount of the boost/cut. Negative (-) settings
produce a cut.
GAIN
Frequence
FREQ
HShelv
LShelv
Peak
Q
0
0
Chapter 5. Control room settings
92
Summary of Contents for V-DRUMS TD-10
Page 21: ...Quick Start Quick Start 21...
Page 131: ...Appendices Appendices 131...
