13
IMPORTANT NOTES
Using the built-in connection cables of the MDS-12, connect
the pads, cymbals, hi-hat, and kick trigger pad.
To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.
fig.Setting1.e
•
The HI-HAT and RIDE cymbal use two cables each.
See the TD-12 Owner’s Manual (p. 20 and p. 52).
• Adjust the VH-11’s offset.
* Do not pull or stretch the cables too tight.
Assemble the “TD-12K”
T1
T2
PD-85
PD-85
T3
PD-85
RD
(BOW/BELL)
RDE
(BOW/EDGE)
CY-12R/C
CY-12R/C
CR1
(BOW/EDGE)
CY-12R/C
CY-12R/C
KIK
KD-85
SNR
PD-105
TD-12
HH
(TRIGGER OUT)
HHC
(CTRL OUT)
VH-11
VH-11
TD-12 Rear Panel
KIK
SNR
T1
T2
T3
HH
HHC
CR1
CR2
RD
RDE
AX1
AX2
* When connecting the cables, please refer to the marking labels
that are attached to both ends of the cables.
The MDS-12 is designed for right-handed drummers.
For left-handed users, the manner in which the pipes
should be configured and the way the cables need to be
run differ from what appears here, so a proper setup
cannot be achieved simply by following this manual.
For instructions on setting up the unit for left-handed
users, refer to the following:
http://www.roland.com/products/en/TD-12K/index.html
TD-12K_e 13 ページ ２００７年６月２７日 水曜日 午前１１時５４分
