11
KIT EDIT
SETTING
MEMO
Use the cursor [ ] [ ] buttons to move to settings such as SEND/FILTER and LIMITER.
PAD SEND LEVEL/FILTER
Here you can specify how the overhead applies for each pad.
Parameter
Value
Explanation
Pad Filter Select
BYPASS, 1–4
Overhead input filter selection for each pad
BYPASS
The input filter is not used; the sound is sent directly to the overheads.
1–4
The sound is sent to the specified input filter.
Pad Send Level
-INF–+6.0dB
Depth of overhead for each pad
[F5] button (H & R)
H&R OFF, H&R ON
Specifies whether head and rim of instruments are selected as a set (ON) or independently (OFF).
PRE LIMITER
This is a limiter/compressor applied before the sound is input to the overhead.
Parameter
Value
Explanation
Pre Comp Switch
OFF, ON
Turns the pre limiter on/off.
Gain
-24.0–+24.0dB
Output volume of the pre limiter
Threshold
-60–0dB
Volume level at which compression begins
Ratio
1:1–100:1
Compression ratio
Knee
HARD, SOFT1–3
Attack of the sound at the moment compression is applied
Attack
0.1–100mSec
Time from when the volume goes up the threshold level until the compressor effect applies
Release
10–1000mSec
Time from when the volume falls below the threshold level until the compressor effect no longer
applies
MIC SETTING
These are the overhead mic settings.
Parameter
Value
Explanation
Mic Type
TYPE1–4
Type of mic
Mic Width
0–4
Distance between mics
Distance
0–6
Distance between the mics and the performer
Output Width
DEFAULT, WIDE+1–+6
Sense of space for the overhead sound
