47
Multi-Effect Parameters
AUTO WAH
Cyclically controls a filter to create cyclic change in timbre.
Parameter
Value
Explanation
Filter Type
LPF, BPF
Type of filter
LPF:
The wah effect will be applied over a
wide frequency range.
BPF:
The wah effect will be applied over a
narrow frequency range.
Manual
0–127
Adjusts the center frequency at which the
effect is applied.
Peak
0–127
Width of the frequency region at which the
wah effect is applied Increasing this value
will make the frequency region narrower.
Sens
0–127
Adjusts the sensitivity with which the filter is
controlled.
Polarity
UP, DOWN
Direction in which the filter will move
UP:
Move toward a higher frequency
DOWN:
Move toward a lower frequency
Tempo Sync
OFF, ON
Specifies whether the modulation rate is
specified as a note value (ON) or not (OFF).
Rate
0.05–10.00Hz,
note
Frequency of modulation
Depth
0–127
Depth of modulation
Phase
0–180deg
Adjusts the degree of phase shift of the left
and right sounds when the wah effect is
applied.
Low Gain
-15–+15dB
Gain of the low range
High Gain
-15–+15dB
Gain of the high range
Level
0–127
Output Level
OD/DS
0
TWAH
Parameter
Value
Explanation
Drive Switch
OFF, ON
Turns overdrive/distortion on/off
Drive Type
OVERDRIVE,
DISTORTION
Type of distortion
Drive
0–127
Degree of distortion
Also changes the volume.
Tone
0–127
Sound quality of the Overdrive effect
Amp Switch
OFF, ON
Turns the Amp Simulator on/off.
Amp Type
SMALL, BUILT-IN,
2-STACK, 3-STACK
Type of guitar amp
SMALL:
small amp
BUILT-IN:
single-unit type amp
2-STACK:
large double stack amp
3-STACK:
large triple stack amp
Touch Wah
Switch
OFF, ON
Wah on/off
Touch Wah
Mode
LPF, BPF
Type of filter
LPF:
Produces a wah effect in a broad
frequency range.
BPF:
Produces a wah effect in a narrow
frequency range.
Touch Wah
Polarity
DOWN, UP
Direction in which the filter will move
UP:
Move toward a higher frequency
DOWN:
Move toward a lower frequency
Touch Wah
Sens
0–127
Sensitivity with which the filter is modified
Touch Wah
Manual
0–127
Center frequency at which the wah effect is
applied
Touch Wah
Peak
0–127
Width of the frequency region at which the
wah effect is applied Increasing this value
will make the frequency region narrower.
Touch Wah
Balance
D100:0W–
D0:100W
Volume balance of the sound that passes
through the wah (W) and the unprocessed
sound (D)
Low Gain
-15–+15dB
Gain of the low range
High Gain
-15–+15dB
Gain of the high range
Level
0–127
Output Level
LOFI COMPRESS
This is an effect that intentionally degrades the tone character for
creative purposes.
Parameter
Value
Explanation
Pre Filter Type
1–6
Selects the type of filter applied to the sound
before it passes through the Lo-Fi effect.
1:
Compressor off
2–6:
Compressor on
LoFi Type
1–9
Degrades the tone character. The tone
character grows poorer as this value is
increased.
Post Filter
Type
OFF, LPF, HPF
Selects the type of filter applied to the sound
after it passes through the Lo-Fi effect.
OFF:
no filter is used
LPF:
cuts the frequency range above the
Cutoff
HPF:
cuts the frequency range below the
Cutoff
Post Filter
Cutoff
200–8000Hz
Basic frequency of the Post Filter
Low Gain
-15–+15dB
Gain of the low range
High Gain
-15–+15dB
Gain of the high range
Level
0–127
Output Level
DISTORTION
Produces a more intense distortion than Overdrive.
Parameter
Value
Explanation
Drive
0–127
Degree of distortion
Also changes the volume.
Tone
0–127
Sound quality of the Overdrive effect
Amp Sw
OFF, ON
Turns the Amp Simulator on/off.
Amp Type
SMALL, BUILT-IN,
2-STACK, 3-STACK
Type of guitar amp
SMALL:
small amp
BUILT-IN:
single-unit type amp
2-STACK:
large double stack amp
3-STACK:
large triple stack amp
Low Gain
-15–+15dB
Gain of the low range
High Gain
-15–+15dB
Gain of the high range
Pan
L64–R63
Stereo location of the output sound
Level
0–127
Output Level
OVERDRIVE
This is an overdrive that provides heavy distortion. The parameters
are the same as for “DISTORTION.”
SATURATOR
A saturator which distorts the sound is connected in parallel with a
compressor, producing a rougher tonal character and boosting the
loudness. This also cuts the low-frequency region of the input audio.
Parameter
Value
Explanation
Saturator Gain
0–127
Input volume to the saturator
Saturator
Drive
0–127
Degree of distortion
Saturator
Level
0–127
Output volume of the saturator
Comp Depth
0–127
Amount of compression
