5
USING THE UNIT SAFELY
Attach the stand holder (included with the optional drum stand) to the TD-3.
Using the screws attached to the bottom panel, attach the holder so the unit is oriented as shown in the diagram.
fig.TD-3.e
• To attach the stand holder, remove the four 8 mm screws (M5 x 8) from the bottom of the TD-3 and use them.
Use of other screws may result in damage to the unit.
928
• When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the
four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient the
unit so no buttons or controls get damaged.
929
• When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.
TD-3
(Percussion Sound Module)
Narrow
Wide
TD-3KV_e 5 ページ 2004年12月16日 木曜日 午後3時43分