100
Chapter 5 Playing Along with Patterns
Setting the Tempo
Setting the tempo for each pattern
When a pattern is selected, the tempo you specify here will
be set automatically.
fig.06-008
1.
Press [PATTERN], then [F3 (
MENU)].
[PATTERN] lights, and a pop-up menu appears.
2.
Press [DEC/-], rotate the VALUE dial, or press CURSOR
[
] to move the cursor to “FUNC.”
3.
Press [F3] to confirm your choice.
4.
Press [F1 (SETUP)].
The “PATTERN SETUP” screen appears.
5.
Press CURSOR [
] to move the cursor to “TEMPO.”
6.
Press [INC/+] or [DEC/-] or rotate the VALUE dial to
make the setting.
7.
Press [PATTERN].
The “PATTERN” screen appears.
PATTERN TEMPO: 20–260
Temporarily Changing the Tempo of a
Pattern During Playback [TEMPO]
This setting temporarily changes the tempo of the pattern
during playback. When another pattern is selected, the
pattern reverts to the tempo (as explained above) preset for
that pattern. This is convenient for practicing or other times
when you want to temporarily change to tempo for playback.
fig.06-009
1.
Follow the instructions in “Choosing a Pattern” (p. 97) to
select the pattern the tempo of which is to be set.
2.
Press [TEMPO].
[TEMPO] lights, and the “TEMPO” screen appears.
3.
Press [INC/+] or [DEC/-] or rotate the VALUE dial to set
the tempo.
4.
When you have finished making the settings, press
[TEMPO].
The [TEMPO] light goes out, and the “TEMPO” screen is
removed from the display.
TEMPO: 20–260
Choosing a Playback Method
(LOOP, ONE SHOT, or TAP)
You can select from the following three methods for playing
back patterns.
LOOP (
):
After the pattern is played back all the way to the end,
playback then repeats, starting at the beginning of the
pattern. Playback continues until [PLAY/STOP] is
pressed.
1SHOT (ONE SHOT) (
):
Playback stops once the end of the pattern is reached.
TAP (
):
Each time [PLAY/STOP] is pressed, the sounds
contained in a pattern are played back one at a time in
sequence.
When set to Pad Pattern (p. 139), the sounds are played
back in sequence each time the pad is pressed.
When choosing the empty pattern, you cannot set “PLAY
TYPE” to “TAP.”
fig.06-010
1.
Press [PATTERN], then [F3 (
MENU)].
[PATTERN] lights, and a pop-up menu appears.
2.
Press [DEC/-], rotate the VALUE dial, or press CURSOR
[
] to move the cursor to “FUNC.”
3.
Press [F3] to confirm your choice.
4.
Press [F2 (TYPE)].
The “PATTERN TYPE” screen appears.
Summary of Contents for V-Drums TD-8
