4-55
4
Gap
4
Enter the [CHECK GAP.] menu in the [SERVICE
MODE] to check the cap adjustment value.
3
Move the cap upward to the position that the cap
contacts exactly to the head, then press [ENTER] to
update the adjustment value.
-When you press [
] key, the cap moves to the upward
direction in 0.25 mm unit.
-When you press [
] key, the cap moves to the position in the
setting value -2.00 mm.
-When you press[
] key, the adjustment value is not updated
and the capping is carried out and then exiting the menu.
The cap moves to the same position as the CAP OPEN
SUCTION is performed. Check if there is the gap between the
cap and head.
[CHECK GAP.] is the menu to check the gap
between the caps and head. For adjustment, use
the [ADJUST POS.] menu.
Head
Cap
Summary of Contents for VersaCamm SP-540V
