2-91
LEF2-300
2
Adjustment
Grease Up Maintenance
•
Always use the UV protection sheet during this adjustment, or ink will harden and clog inside the ink line.
•
This maintenance is to grease the screws of the table UP/DOWN and the plate which fixes the head gap sensor plate. This
maintenance is required in every 6 months.
1.
Apply grease to marked parts of the plate supporting the head gap sensor plate.
•
Grease: FLOIL G-902 10ML_02
•
Volume: as needed
CAUTION
Use the wiry tool since the gaps between the screws and the plate are small. Loosen the screws approximately 1/2 turn to
make the greasing easier.
1. Head gap sensor plate
1
2.
Move the head gap sensor plate back and forth to check that the greased part moves smoothly.
3.
Turn on the power switch and enter the service mode.