2-36
LEF2-300
2
Adjustment
Linear Encoder Setup
Information
Necessary tools
General tools
None
Special tools
None
Typical work time
Contents of work
Time
Linear encoder setup
10 min.
Workflow
CAUTION
Linear encoder setup is performed to confirm that the installation of the linear encoder is proper, and also to confirm that it
properly reads. This operation is required when the limit sensor, encoder scale or encoder sensor is replaced or the position
is adjusted.
1.
Turn on the power switch and enter the service mode.
NOTE
Make sure to unload the media when it is set on the machine.
2.
Select [SERVICE MENU] > [PRINT MENU] > [LINEAR ENCODER] and press the [ENTER] key.
PRINT MENU
NOW PROCESSING...
LINEAR ENCODER
POS: 1361.00mm
SERVICE MENU
PRINT MENU
[ ] [ ]
[ ]