2-38
LEF2-300
2
Adjustment
Flushing Position Adjustment
Information
Necessary tools
General tools
None
Special tools
1000005829
TOOL,VINYL YE UV RESISTANT ST-113
Typical work time
Contents of work
Time
Flushing position
adjustment
5 min.
Cover That Needs to Be Removed
Right panel cover
Workflow
CAUTION
•
This is to adjust the flushing position. This adjustment is NOT required when a cap top and a print head are removed or
replaced. This adjustment is required after performing the limit position & maximum scan width position initialize. Without
this adjustment, the flushing may not be performed properly and that can cause nozzle firing problem.
•
To prevent hardened ink from entering into the nozzle, refresh print head before the adjustment. Perform medium cleaning
on all print heads if 20 minutes passes.
FUNCTION
CLEANING
MEDIUM CL.
FUNCTION
CLEANING
MEDIUM CL.
AB