6
Basic Operations
Turning the Power On/Off
* Before turning the unit on/off, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/off. However, this is normal and
does not indicate a malfunction.
Turning the power on
MEMO
If a USB flash drive containing the still images (p. 15) that were
last loaded is connected when the VR-1HD starts, the still images
are loaded automatically. In this case, startup might take some
time depending on the size and number of the still images that
are loaded.
1
Make sure that all devices are powered-off.
2
Turn on the VR-1HD’s [POWER] switch.
3
Turn on the power in the order of source devices
0
output devices.
Turning the power off
1
Turn off the power in the order of output devices
0
source devices.
2
Turn off the VR-1HD’s [POWER] switch.
Operating the Menu
Here’s how to access the menu, and make video/audio settings
and settings for this unit. The menu is shown on the display that’s
connected to the MONITOR (MENU) connector.
1
Press the [MENU] button to display the MENU screen.
The menu is organized into functions.
2
Turn the [VALUE] knob to select the menu item that you
want to edit, and press to confirm.
3
Repeat step 2 as needed.
Pressing the [MENU] button moves you back one level higher.
4
Turn the [VALUE] knob to edit the value of the setting,
and press to confirm.
5
By turning the [VALUE] knob while pressing it, you can change
the value more greatly.
5
Long-pressing the [VALUE] knob returns the current menu item
you’re setting to its default value.
5
Press the [MENU] button several times to close the menu.
MEMO
5
The contents of the menu settings are saved to the unit every
four seconds or when you close the menu.
5
When you press the [LEVEL SETUP] button, the menu for
volume, input gain, solo, and mute settings appears (p. 42).
5
There are shortcuts that let you quickly access the menu for
specific buttons and knobs.
For details, refer to “Shortcut List” (p. 48).
5
If you want to temporarily change where the menu is shown
If you start up the VR-1HD with the following operation,
the menu is shown on the display connected to the MAIN
connector and on the USB STREAM output.
While holding down the [MENU] button and the [VALUE] knob,
turn on the power. When the unit becomes operable, release
the button and knob.
* The menu will no longer be shown on the display connected to
the MONITOR (MENU) connector.
* Operations of the [ON AIR] button (p. 14) will affect only the
output of the MONITOR (MENU) connector.
About the Auto Off function
The power to the VR-1HD turns off automatically when all of the
following states persist for 240 minutes (Auto Off function).
5
No operation performed on the VR-1HD
5
No audio or video input
5
No equipment is connected to the MAIN/MONITOR (MENU)
If you do not want the power to be turned off automatically,
disengage the Auto Off function. Press the [MENU]
button
0
“SYSTEM”
0
set “AUTO POWER OFF” to “OFF.”
* If the auto-off function has turned off the power, slide the
[POWER] switch when you want to turn the power on again.
