6
MIDI Setup Menu
V-L : Setup Menu
You can perform settings for the V-LINK mode. These settings will go into effect when the VR-3 receives a V-LINK ON message;
these settings will not affect settings made for normal mode.
If you find a value is "DFLT xxx", this is the typical value specified by the V-LINK standard. It can also mean the value previously
specified by a V-LINK setup message. When the unit receives a V-LINK OFF message, any previously sent V-LINK setup data will
revert to the default values of the V-LINK standard. This will also occur when you power cycle the VR-3.
If you have selected the value other than [DFLT] in the menu, the V-LINK setup message will be ignored and the value you have
set in the menu will take priority.
V-L : DEVICE ID
This sets Device ID to receive V-LINK message.
V-L : CLIP CTRL CH
This sets Rx channel for video switching.
V-L : NOTE CTRL MODE
This sets control mode when you switch video channels using note messages.
V-L : NOTE CTRL UPPKEY
This sets the upper key of the note when you switch video channels using note messages.
V-L : NOTE CTRL LOWKEY
This sets the lower key of the note when you switch video channels using note messages.
V-L : TRANSITION TIME
This sets assignment of the transition time control.
V-L : TRANSITION SEL
This sets assignment of the transition type selection.
V-L : AUDIO LEVEL CTRL
This sets assignment of the output audio level control.
V-L : COLOR CTRL CH
This sets the Rx channel of the video output fade control.
V-L : OUTPUT FADE CTRL
This sets assignment of the video output fade control.
