Audio Operations
39
Using the AUX Bus
The VR-3EX has two built-in audio buses (a MAIN bus and an AUX bus). You can select the audio bus to output for each individual connector.
MAIN bus
This receives all input audio as a group and sends it to output (main output audio).
AUX bus
This lets you selectively choose and mix the input audio to send, and sends it to output. You can output different audio than the main output
audio.
For example, you can use this at a live performance venue to output a mix of all input audio (MAIN bus), and when recording or streaming a broadcast,
you can use this to output just certain specific input-audio streams (AUX bus).
MEMO
•
Reverb (p. 37) is not applied to audio on the AUX bus.
•
You can align the timing of AUX bus audio and video. For details, refer to “Aligning the Output Timing of Video and Audio (Lip-sync)” (p. 38).
Assigning an Audio Bus to Audio Output
Connectors
1.
Press the MAIN [SETUP] button.
The setup screen for main audio output is displayed.
2.
Touch <BUS SELECT>.
The BUS SELECT screen is displayed.
3.
Touch the switch section for the output connector for
which you want to change the audio bus for output
4.
Turn the [VALUE] knob to select the MAIN bus or AUX bus.
5.
Press MAIN [SETUP] button twice to quit the BUS SELECT
screen.
Sending Audio to the AUX Bus
1.
Press the [SETUP] button for the input audio you want to
use on the AUX bus.
The setup screen is displayed.
2.
Touch <AUX SEND>.
3.
Turn the [VALUE] knob to adjust the send level for the
audio to the AUX bus.
4.
Press the [SETUP] button to quit the setup screen.
Adjusting the Volume Level of Output Audio on
the AUX Bus
1.
Press the MAIN [SETUP] button.
The setup screen for main audio output is displayed.
2.
Touch <AUX LEVEL>.
3.
Turn the [VALUE] knob to adjust the volume level of AUX-
bus output audio.
4.
Press MAIN [SETUP] button to quit the setup screen.
