30
You can connect up to six cameras via the LAN port and remotely control them from this unit.
Remote cameras made by JVC and Panasonic are supported.
* Refer also to the owner’s manual of your camera.
Network Settings on the Camera
In order to control a camera from this unit, you need to make
network settings on the camera. You can register up to six cameras.
1
Press the [MENU] button
0
touch <
>
0
Network
<Camera Control>
0
<Setup>.
2
Touch a menu item to select it, and make network
settings.
Menu item
Explanation
Camera ID
Selects the camera to be controlled.
Protocol
Specifies the camera’s protocol.
JVC camera:
JVC
Panasonic camera: Panasonic
Login Name
When “PROTOCOL” is “JVC”
Touch to access a screen where you can input the
login name. Enter the log-in name needed to connect
with the camera.
Password
When “PROTOCOL” is “JVC”
Touch to access a screen where you can input the
password. Enter the password needed to connect with
the camera.
IP Address
Input the camera’s IP address.
3
Press the [MENU] button to close the menu screen.
Registering Camera Settings in a Preset
Up to eight sets of settings such as camera position and focus can be
registered as presets.
A registered preset can be recalled when needed.
* Presets are saved in the camera itself.
1
Press the [MENU] button
0
<
>
0
Network <Camera
Control>
0
“Camera” to select the camera ID that you
want to operate.
2
To operate camera settings, touch <
>
0
and touch
the screen to select menu items.
Menu item
Explanation
Positioner
Adjusts the horizontal position. (*1)
Adjusts the vertical position. (*1)
Speed
Adjusts the speed at which the camera
changes direction.
Zoom
Fast
Wide
Zooms-out at high speed. (*1)
Tele
Zooms-in at high speed. (*1)
Slow
Wide
Zooms-out at low speed. (*1)
Tele
Zooms-in at low speed. (*1)
Reset
Resets the zoom position.
FOCUS
Near
The focus moves closer. (*1)
Far
The focal point moves farther away. (*1)
Auto
If this is “ON,” the focal point is set
automatically.
Exposure
Auto
Specifies the exposure mode (auto/manual).
If this is on, auto mode is enabled.
TALLY
Ch
Specifies the number of the video input to
which the camera’s video is being input.
When the camera video from this unit is the
program output, the camera’s tally light is lit.
(*1) The camera is operated while you touch the item.
Remotely Controlling a Camera
