1
2
a
b
3
Stand assembly instructions
1 - Place the Stand Platform (A) upside down. You
will know it’s upside down because the four corner
protrusions will be recessed when compared to the
rest of the surface. If you see the ridges on the center
crossbars, please flip Stand Platform over.
2 - Pick up any of the four Stand Legs (B). Place the
Stand Leg on any one of the recessed rectangular
corner areas of the Stand Platform. The flat edge of the
Stand Leg should perfectly align with the three edges
of the corner.
3 - Thread a screw into the Stand Leg hole using the
provided Hex Key (F). Always begin screwing with the
Hex Key in a vertical orientation. Tighten with the Hex
Key in a horizontal orientation. Repeat this process for
the 3 other legs.
