Notice originale : Français NT0002 V –p – 03/2014
19
Manual mode:
Manual mode is activated by changeover from the 2
nd
switch (6) to
« manual », but there is then no speed adjustment. The hydraulic block can be
varied by the intervention potentiometer which will alter the current which
can alter the current from 0 to the highest factory setting.
Ticket Printing (Option) :
Stop mode :
Stop mode is reached by centring the switch (6), which causes a ceasing of adjustment.
A page which allows the configuration of
the system reactivity index, this setting is to
be adjusted in order to avoid belt pumping.
A page indicating work time (belt
deployment time) since it was last reset to at
zero. Resetting to zero can be done by
pressing touch for this counter (4)
.
Page indicating working time (total belt
operating time) since being brought into
service. It is not possible to reset this counter
to zero.
Client :
------------------------
Surface : 10.0 Ha
Time : 0010 H 25min
P 20) Press on the pushbutton which is to be found on the upper FPD lid
in order to give ticket print-off order.
The printing settings are as follows:
-
The surface area worked since last zero reset of the part-hour
counter.
-
Time in service since last reset to zero on the hour gauge
Page which indicates in metres the total belt
travel distances since it was last reset to
zero by pressing on touch(4)
-
It isn’t possible to print a ticket if you’re on the main
page.
