Notice originale : Français NT0002 V –p – 03/2014
24
Pneumatic braking on two axles at (example) (40 km/h)
Installation of the drive shaft:
PROCEDURE
. All transmissions should be covered by a protector in a good state of
repair
. Any protector found below these standards should be replaced
immediately
Do not forget to install protectors and to fasten them by their chains.
Never start up power take-off without the required protectors being in
place.
. Wearing loose fiting clothing can be a source of accident.
. At the time of first use, it may prove necessary to adjust transmission length. To do
this :
Ensure the correct length of drive shaft tubing.
The tubes must not hit against the crossbeams during extreme turning manoeuvres
Minimum tube casing 500mm
There are several types of security on the tubes; traction bolt shearing or cam shaft security.
In the event of track bolt shearing the bolt must be replaced with the same type and quality as
the original one. Replacement with a more solid bolt will cause the vehicle to deteriorate.
N.B : For starting off en route, the use and maintenance of (primary and secondary)
transmission) please refer to the specific notices supplied with the machine by the
manufacturer.
