Notice originale : Français NT0002 V –p – 03/2014
41
6.
Regulator and hydraulic central maintenance:
Stop the vehicle (see §1-1 on page 3)
Check the oil and seal the reservoir. Think about draining the oil and change the filter
regulator every year. To change the filter, unscrew the bowl guard (red). Clean the inside
of the bowl with a cleaning agent (do not use cloth or paper towels), replace the filter and
then put the bowl.
Check the multiplier housing oil level. Perform a first emptying after 50 hours of use and
every year minimum.
Check the condition of the hose.
7.
Rug Control
:
Stop the vehicle (see §1-1 on page 3)
Check the wear nuts and bearings, lubrication is required (greasing).
Check the condition and attachment of the
rug
bars.
8.
Transmission maintenance:
The maintenance of this organ is essential for your safety.
Stop the vehicle (see §1-1 on page 3)
Check as often as possible the protection of the gimbal.
Lubricate the various components of the Power Take-Off and the bearings of the shaft
(periodicity page 31).
Check the wear wedges and greasing on the transmission shaft.
Also grease the Power Take-Off at the ends of angle transmissions.
To optimize the operation in direct tractor, free return without brake (push-pull) is
recommended.
-
Direct tractor output approximately 60L/min for a manual adjustment, MTKA
type, if not there is an overheating risk and possibility of engine breakage.
-
Tractor output approximately 80L/min for a proportional adjustment with
electric command on cabinet.
-
Every year, draining the oil from the plant, change the filter regulator and change
the strainer pot of the central.
ALL WORK AT EACH ELEMENT OF
TRANSMISSION (SHAFT, UNIVERSAL JOINTS,
BEARINGS,...) MUST BE MADE WITH THE
MACHINE COMPLETELY STOPPED (STOP THE
TRANSMISSION AND ENGINE TRACTOR).
REMOVE THE KEY.
