14
2.5 Powering the Device On / Off
2.5.1 Auto Power On/Off
Once the vehicle engine is started, the device automatically turns on. If
the Automatic Record function is enabled, the recording will automatically
start right after the device turns on.
Please refer to Set Automatic Record (2.6.2).
2.5.2 Manual Power On/Off and Reset
2.5.2.1 Manual Power On
Push the power switch and
make sure that the power switch
locks on the memory card slot.
2.5.2.2 Power Off
Push the power switch and
make sure that the memory
slot is released and the device
starts power off sequence. Do
not power on the device when
it is in the power-off sequence,
or the recorded file may become
corrupt.
2.5.2.3 Reset the device
In case the device fails to function normally due to unknown causes, push
the power switch and verify the memory card is in the removable state;
wait for 7 seconds and push the power switch again to restart the device.
Summary of Contents for CarDVR-310
Page 1: ...CarDVR 310 User Guide in English www rollei com ...
Page 35: ...35 ...