Introduction
Getting Ready
Taking Pictures
Playback
Set Up
GB-12
What Your Camera Can Do
|
Nomenclature
|
Names of the menus and icons shown on the screen
|
LED display
|
FCC
Compliance Statement for American Users
|
Handling Precautions
NEXT
BACK
Contents (Top page) Detailed Contents
Index
Nomenclature
Menus and Settings
Troubleshooting
F
CAUTION
• Do not direct the camera lens directly toward the sun when shooting, since the
CCD element may be damaged.
• Clean the camera well after using it at the beach or other locations subject to
large concentrations of sand or dust. Salt air may promote corrosion of metal
components and damage or short circuits in electronic parts, causing the
camera to emit smoke or catch fire. Sand inside the camera may result in
internal damage and operating malfunctions.
• If the camera is brought quickly from a cold place to a warm room,
condensation may form on the lens and internal parts. Such condensation
may result in damage or short circuits in electronic parts, causing the camera
to emit smoke or catch fire. Whenever possible, avoid subjecting the camera
to sudden changes in temperature.
• When taking the camera overseas or using it to record
important events, check its operating condition and take test
pictures beforehand to confirm proper operation.
• This camera is a precision electronic instrument, and should be protected
from impacts and falls that might cause damage to internal parts or the
emitting smoke and ignition by the shorting of circuitry.
• This camera is an electronic device which uses a high-performance IC. During
use, the camera may grow warm due to heat emitted by IC. While this is
normal, note that holding the camera for long periods risks low temperature
burns.
• This camera is not designed to be waterproof, and cannot be used in the rain
or under water. If the camera should inadvertently be exposed to water, it
should be taken quickly to a Rollei Service Center for inspection.
• Take great care to keep the photography lens and light sensor clean since
soiling such as fingerprints can affect the accuracy of the camera's metering
and focusing functions. If these areas become soiled and require cleaning,
wipe them gently with a third-party lens cleaning cloth. Any dust should be
removed using a blower or lens brush.
• Clean the camera body by wiping with soft cloth. Never use benzene, thinner,
or other volatile solvents or cleansers, since such substances will damage the
body materials.
• Do not remove the SD memory card or MultiMedia Card (MMC) while the card
access LED is flashing (e.g. immediately after photography or playback).
• Interference may occur in recorded or played back images when the camera
is used in areas subject to strong electromagnetic interference (e.g., near a
television set or stereo speakers).
• If the camera is dropped, it may be damaged internally or parts may have
been dislodged even when there is no visible external damage. The camera
must be taken to a Rollei Service Center for checking.
• Do not attempt to touch the insides of the memory card slot, since damage or
malfunction may result.
