69
Flash Exposure Bracketing
By using FEB the flash exposure will be automatically changed, which helps in
conditions of invariable background exposure . You can take three flash shots while
automatically changing the flash output according to 1/3 to plus or minus .
After the FEB is done, the flash will go back to the standard settings that have been
used before . (This can be turned off in the custom settings .)
For using FEB set your camera into the mode “single shot” and ensure that the flash
is ready . Connect the Canon camera and set on the flash exposure value surrounded
exposure .
If a Nikon camera is connected the flash exposure information will not be shown on
the flash . You need to refer to the camera settings .
FEB Setting Surrounded by Exposure Value
(effective for Canon cameras only)
Press the middle button to enter the settings
of the exposure value .
1 . The exposure value can be adjusted by the dial .
Rotate it clockwise to increase or counter clock
wise to decrease the exposure value .
2 . The exposure value has a range of 0 to 3 .0
3 . The values are:
4 . After the settings are done press again the middle button to exit the settings .
0
1
1.3
1.7
2.0
0.3
0.7
2.3
2.7
3.0
