95
Wireless Master Mode (command) (Nikon)
3. Each slave unit group power setting
Press the middle button repeatedly until group A is highlighted (assuming that
for group A has been set a mode) to set the power . The setting will be done in
the same way as described before for the group mode setting . After the setting is
done, press the middle button to enter the next group .
Multi Wireless Master Mode (INSTRUCTION MODE MASTER) (Nikon)
If the master unit is in Multi mode the slave funit supports the multi mode or
wireless off .
1. Press the mode button repeatedly until
the display of the master flash is showing
Multi.
2. Each slave group mode setting.
Group A:
Press the zoom button repeatedly until
A and the mode is highlighted . Rotate the dial to
change the mode of group A . After the setting is
done, press the middle button to exit or to press
the zoom button again to continue with the
setting of group B .
Group B:
Press the zoom button repeatedly until
B and the mode is highlighted . Rotate the dial to change the mode of group B .
After the setting is done, press the middle button to exit or to press the zoom
button again to continue with the setting of group C .
Group C:
Press the zoom button repeatedly until C and the mode is highlighted .
Rotate the dial to change the mode of group C . After the setting is done, press
the middle button to exit .
If the slave unit group setting is done, the groups that have a group mode will be
shown on the display .
