2
Rollerdor RD1X2 Control Box, Edition 2022/1
1. INSTALLING RECEIVER BOX
1
Remove the lid of the receiver box by squeezing
each side at the bottom where the wires come
into the box
(fig.1A)
.
2
Place the Receiver box on the wall with the cable
pointing downwards at a comfortable height to
operate the push buttons, but out of the easy reach
of children. Between 1500mm up from the floor and
300mm down from the roof/ceiling is recommended.
3
Making sure the box is square, mark the three
fixings (one top and two bottom), then drill and
secure with fixings
(fig.1B)
.
4
Remove the green 4 terminal block in the bottom
left corner and you will see letters printed
on the circuit board.
5
Wiring as follows
(fig.2 & fig.3)
;
Pre wired Mains Power:
N
– Neutral / Blue power cable
L
– Live / Brown power cable
Earth
– Earth power cable
Motor:
L
– Brown motor cable (4 core)
R
– Black motor cable (4 core)
Earth
– Earth connection motor cable (4 core)
N
– Blue motor cable (4 core)
Safety Brake:
Remove red link wire from G and S, wire 2 core
cable as follows;
G
– Blue safety break cable (2 core)
S
– Brown safety break cable (2 core)
fig.2 (no safety brake)
fig.3 (safety brake)
DELETING REMOTE CONTROL HANDSET’S MEMORY
1
Press and release the black programming button located at the top middle of the receiver box just below
the fixing screw, the green LED will start to flash
(fig.1)
.
2
Press and hold the black programming button again and the green LED will start to flash faster.
When this happens, release and press again one more time, the green LED will go out.
3
Test to see if remote operates barrel.
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
fig.1
A
A
B
B
B
