3
Rollerdor RD20X2 Control Box, Edition 2022/1
1
Press and hold the bottom close button on the receiver board
(fig.5)
. This is located at the bottom
right corner of the yellow transformer and the barrel should start turning in the downwards
direction. Should the barrel be turning in the upward direction, swap motor
wires black to U and brown to V.
DIRECTION OF ROTATION
fig.5
fig.4
8
Before plugging in, check to make sure that there
are no bare cables touching and all wires are
securely fixed.
9
There is a four dipswitch block at the bottom
middle of the receiver board (usually blue or red).
Slide dipswitch 2 into the up position
(fig.5)
.
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
