6
Rollerdor RD20X2 Control Box, Edition 2022/1
1
Press and hold the “RADIO PROG” button
(fig.11A)
. You will hear a beep and the red
LED alongside “C1” will illuminated
(fig.11B)
.
Then release the “RADIO PROG” button.
2
Press top button on handset
(fig.11A)
.
The panel will beep to confirm it has accepted.
Repeat for all other handsets.
3
Leave for several seconds and the receiver box
will beep twice to confirm end of programming.
SEQUENTIAL OPERATION
1
Press and hold the “RADIO PROG” button
(fig.11A)
until you hear 3 beeps and the red LED
alongside “C3” will illuminate then release the
button.
2
Press top button on handset
(fig.12A)
.
The panel will beep to confirm it has accepted.
Repeat for all other handsets.
3
Leave for several seconds and the receiver box
will beep twice to confirm end of programming.
4
Press and hold the “RADIO PROG” button
(fig.11A)
until you hear 4 beeps and the red LED
alongside “C4” will illuminate then release the
button.
5
Press bottom button on handset
(fig.12B)
.
The panel will beep to confirm it has accepted.
Repeat for all other handsets.
6
Leave for several seconds and the receiver box
will beep twice to confirm end of programming.
INDEPENDENT BUTTON OPERATION
fig.12
A
B
3. PROGRAMMING OF REMOTE
CONTROL HANDSETS
fig.11
A
B
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
