9
Rollerdor RD20X2ANSA Control Box, Edition 2022/1
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
WIRELESS KEY PAD
INSTALLATION
1
Undo and remove the two back-plate securing screws from the top and bottom of the unit and remove the
back-plate.
2
Using the back-plate as a template, mark the positions of two suitable fixing holes onto the wall then
secure the back-plate to the wall using the plugs and fixing screws provided.
3
Remove the battery cover from the rear of the keypad and fit the 9 volt battery supplied. Refit the battery
cover and fixings. Push the keypad onto the back-plate and secure in place with the two fixing screws.
fig.20
PAIRING USING ACCESS CODE
1
The keypad is supplied with factory pre-set master code number "9999"and factory access code number
"1234".
2
To pair keypad to receiver box, press and hold the operation button on receiver box next to the RED LED for
roughly 5 seconds and release when the RED LED goes out
(fig.13 & fig.14)
.
3
The RED LED will flash once to say it is programming mode: Enter the factory access code “1234" (the LED
keys flash to confirm each key entry and then flash twice once full code has been entered to indicate the
correct access code) the red LED on the box will flash once again to confirm programming.
4
Wait 30 seconds for the RED LED to come back on solid and the door is out of programming mode and ready
to use, test keypad code to check and repeat the process if programming hasn’t worked.
